Jump to content

gearcase

Members
  • Content Count

    23
  • Joined

  • Last visited

Community Reputation

0 Neutral

About gearcase

  • Rank
    Novice
  1. Same here. Nothing but trouble. Bought GPS Speedo, Tach, H2O PSI, head temp, volt, and trim guages. You do the arithmetic. Not just a buck or two, doncha know. Volt gauge read 2 volts low from day one. Told them about it and they had me send it back for service. They tested it, said it was 'within tolerance', and sent it back. I have 3 other boat volt gauges and 4 DVMs that all show the right voltage. Go figure. Tach was flakey at higher RPMs from the get-go too. Finally quit altogether. In their defense, they WERE able to see the problem with the tach and sent me a ne
  2. winter is here . anyone got any new parts to bolt on. id like to use my seastar helm with a wing plate and ram that i have. any sugestions. i have a reynolds racing yoke on the seastar set up now. it drives great. but i know the ram set up is strongest. the ram i have now was with a capolono helm. i run only av gas in my 2.5 for a couple years. anyone like to run it?? V P racing in ca. is $8 to 9+ a gallon av is 4+ or -
  3. did you find a euro yet ??
  4. STVMATT that is a great running stv 110 full load is going good!!!!. is that a 300x or a 300?? 118 is haulin your good togo. its not a 46 skater u know. its a rush to run a big### but it takes time and $$$ to do it safe. there are no garnties.
  5. firestarter thanks for your reply i hope it is stronger than you sugest though. have you seen one in person. i think it may be stonger than you think. of course i like the lathem ram wing plate set up the best just havnt done it.
  6. Agreed then, that I wouldn't call safe. The dual opposed setup like I have has 2x the number of bolts and attachment points. any one using a renalds racing stering yoke on there sea star set up. i bought and installed one on my euro with the sea star stering it bolts to the adapter plate on both sides and then to the tiller arm wth a ARP bolt and nylock nut. if tiller fails its still attatched at the adapter plate. botls up like a wing plate but not with the ram ect. anyone else using this renalds racing stering yoke??
  7. Agreed then, that I wouldn't call safe. The dual opposed setup like I have has 2x the number of bolts and attachment points. any one using a renalds racing stering yoke on there sea star set up. i bought and installed one on my euro with the sea star stering it bolts to the adapter plate on both sides and then to the tiller arm wth a ARP bolt and nylock nut. if tiller fails its still attatched at the adapter plate. botls up like a wing plate but not with the ram ect.
  8. rpm nice looking boat. good luck with the supercharger. what is the apllication for it? car motor, or outboard.
  9. gearcase

    propeller

    thanks anthonySS gearcase is a sportmaster, motor is on the transom. no jackplate, i need to measure hieght. and i have been runing motor pretty nutral and have been bump in it up. no trim gauge. wont be running it for a couple of weeks though.
  10. gearcase

    propeller

    runnin a 2000 stv euro 2.5 Efi. have a 14.5x26 round ear chopper and a 14.5x30 merc lab cleaver. i have not run the cleaver yet. will try next time out. I know it will not be as quik. but i know the chopper is a bow lifting prop and the boat has got loose with this prop. anyone have a prop they like best for the euro? Thanks !
  11. Thanks W.Tripp I talked to Brian at bnd im thinking about runin it
  12. thanks Liqui-fly ill check the site
  13. thanks for the replys any one know were to buy TK-7 thanks.
×
×
  • Create New...