Jump to content
Sign in to follow this  
Corwette

procomp set up

Recommended Posts

I have had a few twin tunnels and now have purchased a 1991 Procomp with no power. Installed a rebuilt 1993 Yamaha 250 HPDI with a stage 3 kit lifted the compression a bit. Flashed he computer. With 6" set back manual jack plate. Getting ready to send off the lower to HT for low water drilling and some reshaping. Since the procomp needs to run above pad an inch or so do I need to run a fat shaft as well?

Also the Yamaha is heaver than Merc 2.5 by over 100lb what type of prop should I be using?

I have a lab 28p 4 blade Merc bravo will this have to much lift? Please let me know what you think.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...